Can i stack my fridge and freezer

In the case of a future universal stacking kit, carefully check the measurements of the kit before purchasing, to ensure it is a good fit for your Bosch units. Pending the possible introduction of a stacking kit for Bosch fridges and freezers, there is a workaround. You can safely stand either a fridge or freezer below a worktop and the other unit on top of the worktop.

Naturally, the worktop has to be securely fixed in place to ensure this is a safe option. Although they would not be stacked, they would be in a very similar configuration. RottenFox Distinguished Member. IronGiant said:. We have freezer under the worktop and fridge on top of worktop. The worktop takes the weight of the fridge and there's no chance of it slipping off. We can also pull out the freezer for the occasional clean underneath it.

Im with everyone else, Safe and not a problem. About the only issue you might have is that the top appliance will be affected by the rising heat, which may reduce its life a bit no idea how much but probably not much and make it a little bit less efficient. You must log in or register to reply here.

Similar threads. Logik fridge freezer query. Replies 1 Views Aug 2, outoftheknow. Cheap fridge for use in the garage. Replies 8 Views 1K. May 6, DigitalDigger. Oct 29, Broadsword. Replies 0 Views Quote from: andrewc on 14 March, , pm. Thanks, I've looked at that option now. The issue is that I haven't got much space to work with and those legs are mm in diameter and I only have mm width to play with, so something slimline is needed.

I did this recently for Miss Ham's flat, as has been mentioned, there's no worry about distorting the frame, the feet are at the edge and very unlikely to cause distortion. What you need to think of is locating it securely in the horizontal plane. If you can reduce the side to side movement, front to back should look after itself.

The typical freezer top is some kind of plastic, which makes slipping about more of an issue. Think about using padding on each side to locate it.

Twinslot perhaps if you can fit them in the available space which would need ply shelf and to be fully screwed as you will have a cantilever projection or alternatively, again if space allows.